Turn Device On and Off

Learn how to power your Moasure device on.

The way your Moasure device turns on depends on the model:

• Moasure 2 & Moasure 2 PRO: Turn on by rotating the device through 180 degrees

• Moasure ONE: Turn on by double tapping (default), or rotating if enabled (firmware v1.28+)

Turn on Moasure by Rotating

With STICK: Raise the STICK and hold it out horizontally in front of you, then rotate it 180° back and forth until the LED indicator starts flashing blue.

Without STICK: Hold the device between your thumb and index finger, keep it vertical, and rotate it 180° until the LED indicator starts flashing blue.

Rotate 180° back and forth until the LED flashes blue.

Turn on Moasure by Double-Tapping (Moasure ONE Only)

With STICK: Place the STICK on a flat, solid surface, then double-tap the top corner of your Moasure ONE where the LED indicator is located.

Without STICK: Hold the Moasure ONE in the palm of your hand and double-tap the centre of the green circle to turn it on.

With STICK: double-tap the LED indicator | Without STICK: double-tap the centre of the device in the palm of your hand.

Double-Tap Tip (Moasure ONE) If your Moasure ONE doesn’t turn on, your taps may be too fast or too slow. Try adjusting the speed and firmness of your taps until the device responds.

Change Turn-On Method (Moasure ONE)

Moasure ONE supports both double-tap and rotate-to-turn-on (firmware v1.28 or later).

To change your preferred method:

1. Open the Moasure app and go to Settings

2. Tap Account & Device Management

3. Tap on Device Preferences under Device Management

4. Choose your preferred Turn-On Method

Your device must be turned on and connected to apply changes.

Update Firmware to Change Moasure ONE Turn-On Method

As the rotate-to-turn-on feature is available on firmware versions from v1.28 upwards, you will need to update your firmware version to v1.28 or newer in order to select the rotate-to-turn-on method instead of the double-tap method.

See how to do this here: Update Firmware.

Turn off Moasure

By default, your Moasure device automatically switches itself off after 30 seconds of inactivity. However, you can adjust the device's disconnection time by following these steps:

1. From within the Moasure app, go to Settings (tap the cog in the bottom-right corner of the app).

2. Tap on Measuring Options.

3. Scroll down until you see Moasure Device Disconnection where you will be able to set how long you would like the Moasure device to stay awake. You can choose from 30 seconds, 1 minute, 2 minutes and 5 minutes.