Assemble & Use Moasure STICK

This page covers how to assemble the STICK and how to use it correctly with your Moasure device.

What’s Included

Your Moasure STICK consists of the following components:

• Foam-lined housing for your Moasure device

• Expandable smartphone holder

• Universal rotating joint

• Extendable pole

• Tool bag

Watch the video below for a step-by-step walkthrough, or follow the written steps underneath.

This page covers how to assemble the STICK and how to use it correctly with your Moasure device.

What’s Included

Your Moasure STICK consists of the following components:

• Foam-lined housing for your Moasure device

• Expandable smartphone holder

• Universal rotating joint

• Extendable pole

• Tool bag

Watch the video below for a step-by-step walkthrough, or follow the written steps underneath.

How to assemble Moasure STICK

1. Attach Foam-Lined Housing:

   • Use the screw knob to attach the foam-lined housing to the end of the pole

   • Ensure the pointed corner of the housing faces upwards before tightening

Make sure the housing that holds your Moasure device is pointing upwards

1. Attach Universal Joint:

   • Fix the universal rotating joint to the top of the pole

   • Tighten securely so it remains stable during use

2. Connect Smartphone Holder:

   • Connect the smartphone holder to the universal joint

   • Adjust the holder to fit your phone securely

1. Adjust the Smartphone Holder Angle:

   • Loosen the adjustor screw knob on the universal joint by turning it counter-clockwise.

   • Pivot and adjust the smartphone holder angle as required.

   • Tighten the adjustor screw knob by turning clockwise to secure the holder.

1. Insert Your Moasure Device:

   • When inserting your device into Moasure STICK's cushioned housing, avoid holding the STICK itself to prevent bending and stress on the flexible joint. Instead, turn the STICK upside down and hold the housing, ensuring the LED is visible when looking from above.

   • Ensure to align your Moasure device evenly within the housing during insertion.

Your Moasure STICK is now fully assembled and ready for use.

Enable Moasure STICK in the App

Before measuring, enable Moasure STICK in the app so measurements are taken from the correct reference point.

• Open Settings (cog icon in the bottom-right corner of the app)

• Tap Measuring Options

• Toggle Use Moasure STICK Attachment to On

The reference point is normally at the corner of the device. When Moasure STICK is enabled, this shifts to the tip of the STICK attachment, ensuring all measurements reflect the true contact point with the ground.

How To Use Moasure STICK

Once enabled, use Moasure STICK as part of your normal measuring technique:

• Move smoothly between points

• Keep the STICK steady and upright

• Avoid sudden movements or excessive swinging

• Pause briefly at each point to confirm position

Using a light grip and controlled movement will help improve consistency and overall accuracy.

---

Adjust STICK Height

To use Moasure STICK comfortably, adjust the height so your hand sits around waist level, with your forearm roughly horizontal as you walk.

Hold the STICK between your thumb and two fingers, maintaining a light grip to minimise any swinging while moving.

Hold STICK between your thumb and two fingers, maintaining a light grip